Jacob Dickinson's Discussions
introduction...
Replied Jul. 30, 2008
Optical Tracking
Replied Jul. 28, 2008
Handling Auto/Manual Switch
1 Reply
Started this discussion. Last reply by Chris Anderson Jul. 24, 2008.
Jacob Dickinson's Page
Latest Activity
I bought the new arduino board (the red one), and the Em-408 gps module.
So there are 5 pin on the gps and 6 on the arduino board.
How should I connect the cable between them?!
Em406:
1) GND 2) VIN 3) RX 4) TX 5) GND 6) 1pps
Em408:
1) EN 2)GND 3) ...
Does anyone have any idea what the component is just to the left of the cable, when the antenna is up? I managed to short the ground somewhere when trying to mount it and blew that cap/resistor/fuse whatever - I was hopeful the rest of the board w...
Clarence is right, go NewSoftSerial. I had quite unattended good results with it, even in multiple soft serial instances (one with 34800 and the other with as much as 57600 bauds, once I tweaked the parameter constants in an appropriate h. file to...
AFSoftSerial is somewhat outdated also, might help to try upgrading to
http://sundial.org/arduino/?page_id=61
which builds on the Lady's library.
If you are still completely stuck you may want to give it a shot after all else fails
Check the data bytes. I had this before, it was set to 7bits rather than 8.
Comment Wall (1 comment)
- At 12:50am on August 1, 2008,
Stefanos Samakas said… - Hi Jacob i found very intersting wat are you try do to...
As far i manage to conect my rc gear to a BS2 ic controler just controling the Roll acces from an accelerometer in auto comant and switching if i want in manual comant ...Its easy when using pulsin <> pulsout comants on BS2
What rc gear you have ?
Jacob Dickinson's Blog
EasyStar Project
I’m not going to be able to work on this project for awhile, so I thought I would post about it, partially so that I don’t forget the details myself : )
For those of you who don’t know, I’m currently working on a UAV based on a Multiplex EasyStar and an Arduino Diecimila. My main goal currently is to simply get it to fly from waypoint to waypoint, but in the distant future my goal is to extent flight time as long as possible. I’ve been working on the project for the past couple months, and it’s… Continue
For those of you who don’t know, I’m currently working on a UAV based on a Multiplex EasyStar and an Arduino Diecimila. My main goal currently is to simply get it to fly from waypoint to waypoint, but in the distant future my goal is to extent flight time as long as possible. I’ve been working on the project for the past couple months, and it’s… Continue
Posted on August 11, 2008 at 4:00pm — 4 Comments
© 2009 Created by Chris Anderson
