Two current sensors APM2?

Hello, I have seen in the Wiki that APM2 has two inputs for current sensors, I wondered howto monitor. the Mission Planner. the two batteries, as it only shows one.

I have two batteries, one for motor. and one for servos, rx and APM2. and would like to have control over them.

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Javier Robaina on February 23, 2012 at 11:07am

Well, I'm sure there are more than one person with this same problem.

Another problem I'm sensing is that the Mission Planner I save settings when I select the current sensor 90A attopilot, always fits me like others.

▶ Reply

RSS

Welcome to
DIY Drones

Sign Up
or Sign In

Or sign in with:

Social Networking

Top Content

1	APM Project vs DJI NAZA and WOOKONG
2	APM 2.5 with NEO-6M ublox gps (not 3DR LEA-6)
3	APM Copter 2.9.1.b has been released
4	Flying 3D Spline Curves between Waypoints with ArduCopter 3.0
5	ArduCopter-3.0 ready for wider use
6	10k autonomous flight - telemetry guided flight, and other APM tests!
7	Drone shot down by police
8	MAAT final version is being tested
9	Help Tuning Arduplane 2.73 With A Large Slow Airframe
10	Thirty Days (#28): McMaster-116 lift

RSS
View All

Contests

Season Two of the Trust Time Trial (T3) Contest has now begun. The fourth round is an accuracy round for multicopters, which requires contestants to fly a cube. The deadline is April 14th.

A list of all T3 contests is here.