Hi

I'm having some problems loading a mission from the Config Tool application to the Ardupilot board. Evertime I try to load a basic mission it gives me a error "Something is wrong"


Can anybody please help, I've managed to load code to the board before but now i'm having some problems and i'm not sure why.

Regards

Andre

Views: 81

Reply to This

Replies to This Discussion

When you read the code, does it show that it was in fact properly written? Sometimes that error message shows up even when nothing is actually wrong.
Hi Chris

Yes it does read properly, ok so it works then. thank you very much for getting back to me.

Regards

andre

RSS

© 2014   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service