ArduCopter 3.x (traditional heli) (67)

Discussions Replies Latest Activity

Failsafe. Via Missionplanner or Taranis??

Hi. I have been flying for a few months, but have never set a failsafe on any of my 3 drones. I am looking at it now and I am a bit confuse…

Started by Paul

0 on Sunday

Traditional Heli - Pixhawk Motor Interlock enabled

Hey guys, I think this maybe a common issue here but I have everthing setup with my radio (taranis) and modes all set with the 6 pos switch…

Started by Chad

2 Mar 13
Reply by Chad

APM with traditional Helicopter pitch inverted

Hi,i have a problem:i have a 450 Helicopter with 120° swashplate WITH flybares. two in front and one in the back. but i cant figure out how…

Started by alexandre bhar

1 Mar 8
Reply by Ultrafuge

Pixhawk on traditional helicopter

Hey guys hope everybody is doing well in their Hobby life I'm in the middle of a project and I'm kind of giving up in have installed a p…

Started by Michel Maalouf

3 Jan 28
Reply by Michel Maalouf

Traditional heli build.

   The traditional heli wiki has a page on how to setup traditional heli. However it is very old and it talks of APM 2.X rather than the c…

Started by Cool Dude

2 Jan 27
Reply by Michel Maalouf

regression testing for for simulink blocking set

hi, i'm working on a project which aims to bridge the gap between simulink high level code and arducopter low level code. i bridge the gap…

Started by hanan ber

0 Dec 15, 2016

Overheating BEC

Hiya I've almost finished setting up my CopterX 450 Pro (TT) which has a 50A ESC + BEC - http://www.ehirobo.com/copterx-cx450-10-05-50a-bru

Started by Jamie Brunton

3 Nov 28, 2016
Reply by Crady von Pawlak

Sucessful setup on trad heli with ESC without governor

Hi I would like to know if somebody of you have been successful setting up a heli with Pixhawk using an ESC without governor. Thank you v…

Started by Julio Rodriguez

0 Nov 13, 2016

ArduCopter firmware compilation

I am trying to compile firmware for ArduCopter (Pixhawk). I tried Ubuntu (http://ardupilot.org/dev/docs/building-px4-for-linux-with-make.h

Started by Parth Sharda

0 Nov 10, 2016

Pixhawk: Motor Interlock Enabled

Hello guys. I am new to RC autopilot. I just finished building my GAUI X5 Helicopter and I am trying to integrated it with Pixhawk Autopil…

Started by Usamah Abdul Latif

3 Nov 4, 2016
Reply by Ultrafuge

RSS

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2017   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service